Detection and monitoring vehicles

How to plan a mobile laboratory vehicle

Define the testing workflow before choosing the chassis. Instrument dimensions, operating conditions and supporting services determine whether the proposed vehicle can carry and operate the agreed laboratory.

Representative Fengqi detection vehicle exterior
A representative vehicle from the detection range. The equipment scope is defined separately for each build.

1. Define the mission and instrument supply

Air monitoring, water sampling and laboratory analysis are different workflows. Start with sample type, target measurements, intended method, daily workload and whether measurements take place parked or in motion. A field-screening vehicle is not automatically a complete analytical laboratory.

Identify instruments supplied by the buyer and those proposed by specialist suppliers. Agree responsibility for selection, mounting, installation, commissioning, consumables, training and after-sales support. Vehicle integration does not make the converter the instrument manufacturer.

2. Choose the chassis from the operating weight

Allow for the conversion, instruments, cabinets, water, batteries, generator, gas supplies where required, consumables and people. Compare the resulting mass with the approved vehicle and axle limits. A quoted gross mass is a limit, not the payload available for laboratory equipment.

A van or truck should be selected from the complete layout and weight assessment. Drive configuration, road conditions, service access and destination registration requirements also affect the choice.

Detection vehicle chassis selection · Cab, axle and chassis configurations

3. Plan the body around the workflow

Arrange sample receipt, preparation, measurement and waste handling in the required sequence. Check operator movement, instrument service clearances, storage and the route for replacing equipment. Separate incompatible activities as required by the selected methods and equipment instructions.

Water testing may need clean-water and wastewater storage, a sink, suitable bench surfaces and sample refrigeration. Air monitoring may require sampling inlets, racks and calibration-gas arrangements. These are planning questions, not a standard equipment package.

Water sampling and field analysis · Why laboratory vehicle layouts change

4. Calculate power and environmental services

List each instrument and supporting load, including cooling, pumps, refrigeration and computers. Record voltage, frequency, continuous demand, start-up demand and operating hours. Choose mains, generator, battery and UPS arrangements against the required duty cycle and instrument instructions.

Solar panels and batteries should be assessed against the energy budget, available mounting area and operating conditions. They should not be described as sufficient for the entire laboratory without a load calculation. Confirm ventilation, temperature, humidity and any gas or exhaust requirements with the equipment suppliers.

Power planning for detection vehicles · Generator and power options

5. Agree testing, handover and quotation scope

Define acceptance checks before manufacture: equipment fit, operating weight and axle loads, utilities, installation, functional operation and documentation. Agree instrument commissioning, transport checks, training and support with the responsible suppliers. Laboratory accreditation and acceptance of test methods are separate from vehicle conversion.

A preliminary quotation can use a provisional instrument list, but must identify assumptions, exclusions and items requiring confirmation. Final configuration and pricing depend on the confirmed equipment and scope.

Information for an initial mobile laboratory vehicle quotation
ProvideWhat it establishes
Tests, methods and sample workflowThe required scope and working areas
Instrument list, sizes, masses and utilitiesInstallation, chassis and service requirements
Operators, runtime, climate and roadsOperating weight and field-use conditions
Destination, quantity and target dateDelivery planning and documentation review
Supply and service responsibilitiesWhat is included in the quotation and handover

Compare detection vehicle models · Mobile inspection platforms · Browse published project references

Email Fengqi

Choose how to write to us. You can also copy the address into your usual email service.

Write in Gmail ↗Open email app →

Requires a configured email app. Nothing is sent until you send it yourself.